VP5500/serial howto

Aus LaborWiki
Wechseln zu: Navigation, Suche
Serial pinout


Open the battery cover and disconnect the battery. Then solder 3 wires to the RX, TX and GND pins: Vp5500 serial howto 0001.jpeg

Break of a tiny bit of the back cover. Try to not break the center pin of the back cover since this gives mechanical support for the screw you need to reattach later on. Vp5500 serial howto 0002.jpeg

After re-assembling all the stuff, it should look somewhat similar to this... Vp5500 serial howto 0003.jpeg

<< back to VP5500 main page